Skip to main content

Sådan skiftes kulsyreflaske på Cafeumat Cooler Vandkøler

Denne beholder installeres med godkendt trykregulator/ This container must be installed with an approved pressure regulator.

1 ) Juster ventilen mod uret indtil regulatoren viser 0 bar for at lukke for kulsyren. / Turn the knob anticlockwise until the meter displays 0 bar.

2 ) Afmonter den tømte kulsyreflaske ved at skrue flasken mod uret. (OBS: Kulsyre kan slippe ud.) /Turn the empty canister clock- wise to remove it. (Some gas may escape at this point.)

3 ) Bortskaf kulsyreflasken på ansvarlig vis. / Dispose of the used canister responsibly.

4 ) Fjern beskyttelseshætten fra den nye kulsyreflaske. / Remove the protective cap from the new canister.

5 ) Monter den fyldte kulsyreflaske på trykregulatoren ved at skrue mod uret. (OBS: Kulsyre kan slippe ud.) / Turn the full canis- ter anti-clockwise to secure it to the pressureregulator.

6 ) Juster ventilen på trykregulatoren med uret indtil regulatoren viser 3,5-5 bar. / Turn the knob clockwise until the meter displays 3,5-5 bar.

Note: Er der ikke tilstrækkelig kulsyre tilsat vandet efter montering af ny kul- syreflaske anbefales det at dræne kulsyretanken:
Placer en beholder på ca. 1L og hold knappen til vand med kulsyre inde indtil der ikke kommer mere vand ud – Der injiceres nyt vand i vandkølerens kulsy- retank – OBS der kan gå op til 2 timer før optimal kulsyremængde opnås.

/ If there is not enough carbon dioxide added to the water after installing a new carbon dioxide bottle, it is recommended to drain the carbon dioxide tank: Place a container of approx. 1L and hold the button for carbonated water until no more water comes out – New water is injected into the water cooler’s car- bonated tank – NOTE that it can take up to 2 hours before the optimal amount of carbonation is achieved.